$39 RC1" Water Flow Switch 250V 15A Flow switch 1.0MPa SPDT Contacts Industrial Scientific Hydraulics, Pneumatics Plumbin Fittings amateurhockeycup.com,1.0MPa,/barnstorm545037.html,Contacts,RC1",Industrial Scientific , Hydraulics, Pneumatics Plumbin , Fittings,250V,Water,switch,Switch,$39,Flow,Flow,SPDT,15A Weekly update RC1" Water Flow Switch 250V 1.0MPa 15A SPDT switch Contacts amateurhockeycup.com,1.0MPa,/barnstorm545037.html,Contacts,RC1",Industrial Scientific , Hydraulics, Pneumatics Plumbin , Fittings,250V,Water,switch,Switch,$39,Flow,Flow,SPDT,15A Weekly update RC1" Water Flow Switch 250V 1.0MPa 15A SPDT switch Contacts $39 RC1" Water Flow Switch 250V 15A Flow switch 1.0MPa SPDT Contacts Industrial Scientific Hydraulics, Pneumatics Plumbin Fittings

Weekly update RC1

RC1" Water Flow Switch 250V 15A Flow switch 1.0MPa SPDT Contacts

$39

RC1" Water Flow Switch 250V 15A Flow switch 1.0MPa SPDT Contacts

|||

Product description

Specification:
Model: LKB-01D
Material: Stainless steel, Copper, Plastic
Rated current: 15A
Repeatability error: 2.5%
Regulation range: 5.2-23 L/min
Switch type: SPDT
Connector: RC 1"
Max.working pressure: 1.0MPa

Medium temperature: 0-100℃


Package Included:
1 * Water Flow Switch
1 * User manual

Installation method:
1. Open the flow switch
2. The switch has been set at minimum flow rate. Turn the adjusting screw counterclockwise to increase the flow setting value.
3. Press the target to check whether the micro switch can work normally. Excessive clockwise rotation of the adjusting screw may lead to the failure of the flow switch.
4. After the installation, please press the lever of the flow switch several times to check. If there is no "click" sound, turn the adjusting screw counterclockwise until there is "click" sound.
5. The adjustment screw of lacquer seal is only used for the first time to adjust the state of flow switch. Please do not change or adjust it.
6. Observe three operating cycles to ensure that the switch and the system to which it is connected are operating properly and cover the switch enclosure promptly.

Note:
When installing wiring, please pay attention to the following matters:
(1). It is absolutely forbidden to impact the wrench on the switch base plate, which will lead to the deformation and failure of the flow switch.
(2). When wiring or debugging, cut off the power supply.
(3). When wiring, it is absolutely forbidden to adjust any screws other than micro switch terminals and grounding screws. And connecting the wire carefully, otherwise it is easy to make the micro switch itself position displacement, resulting in the failure of the flow switch;
(4). Special grounding screws must be used for wiring, and installation screws cannot be removed.

RC1" Water Flow Switch 250V 15A Flow switch 1.0MPa SPDT Contacts

Jump directly to the content